Jet Tools JWBS-20 Bedienungsanleitung

OWNER'S MANUALJWBS-20 Woodworking BandsawJET EQUIPMENT & TOOLS, INC. P.O. BOX 1349 Phone: 253-351-6000A WMH Company Auburn, WA 98071-1349 Fax

10Resaw GuideFor resawing attach the post (A, Fig. 13) tofence with the lock knob (B, Fig. 13). There is aslotted hole in the fence that will accommod

11Changing BladesWARNINGDisconnect machine from the power source,unplug!Blade teeth are sharp! Use care whenhandling the saw blade.Failure to comply m

12Adjusting Blade Tension1. Disconnect machine from the powersource, unplug.2. Turn blade tension hand wheel (A, Fig. 18)counter-clockwise to tension

13Brake PedalDepress the brake pedal (A, Fig. 20) while thesaw is running to stop the saw. Re-start the sawby pressing the on switch.Replacing Belt1.

14Electrical ConnectionsWARNING!All electrical connections must be done by aqualified electrician!Failure to comply may result in loss ofproperty and/

15TroubleshootingTrouble Possible Cause SolutionSaw stops or will not start1. Overload tripped2. Saw unplugged3. Fuse blown or circuit breakertripped4

16Upper Wheel Assembly

17Upper Wheel AssemblyIndex PartNo. No. Description Size Qty.1...JWBS20-501... Saw Body...

18Lower Wheel and Motor Assembly

19Lower Wheel and Motor AssemblyIndex PartNo. No. Description Size Qty.1...JWBS20-201... Bearing Base...

2This manual has been prepared for the owner and operators of a JET JWBS-20 Woodworking Bandsaw.Its purpose, aside from machine operation, is to promo

20Index PartNo. No. Description Size Qty.51...JWBS20-84... Spring... ...

21Blade Guides Assembly

22Blade Guides AssemblyIndex PartNo. No. Description Size Qty.1...TS-0051051 ... Hex Cap Bolt...

23Index PartNo. No. Description Size Qty.56...TS-0720071 ... Lock Washer ...1/4 ...

24Table Assembly

25Table AssemblyIndex PartNo. No. Description Size Qty.1...JWBS18-401... Locking Handle... ...

26Electrical Schematic - 230V, 1 Ph

3WARNING1. Read and understand the entire instruction manual before attempting assembly or operation.2. This band saw is designed and intended for use

4Table of ContentsWarranty ...

5Contents of Shipping Container1. Bandsaw1. Table1. Fence and Rail Assembly1. Resaw Guide and Knob1. Miter Gauge1. Owner’s Manual1. Warranty Card1. Ha

6Assembly and Setup1. Attach the handle (A, Fig. 1) to thehandwheel (B, Fig. 1).2. Turn blade tension hand wheel (C, Fig. 1)counter-clockwise to tensi

7Lower Bearing Guide AdjustmentWARNINGDisconnect machine from the power source,unplug before making any adjustments!Blade teeth are sharp! Use care wh

8Adjusting90DegreeTableStop1. Blade tension must be properly adjustedprior to adjusting 90 degree stop, see“Adjusting Blade Tension” page 13.2. Loosen

9Fence Assembly and Adjustment1. Attach the fence (A, Fig. 10) to the fencebody (B, Fig. 10) with four 5/16” x 3/4” hexcap bolts, four 5/16” lock wash