Jet-tools PDS-12CS Bedienungsanleitung

OWNER'S MANUAL PDS-12CS 12” Disc Sander POWERMATIC 427 Sanford Rd. Phone: 253-351-6000 WMH Tool Group LaVergne, TN 37086 Fax: 1

10Collector Bag Assembly 1. Mount the inlet port (A, Fig. 4) to the cabinet with four M6x12 pan head screws (B, Fig. 4). 2. Thread two M6 nuts (C,

11Sanding Disc Replacement 1. Disconnect machine from the power source. 2. Remove the knobs (A, Fig. 7), washers (B, Fig. 7), and trunnion holder

12Emptying the Collector Bag CAUTION Wearing a particle mask/respirator for protection against fine dust particles during cleaning is highly recomme

13Base Assembly Breakdown

14Parts List for the PDS-12CS Base Assembly Index Part No. No. Description Size Qty 1...612083... Closed Stan

15Sander Assembly Breakdown

16Parts List for PDS-12CS Sander Assembly Index Part No. No. Description Size Qty 1...612111... Base...

17Index Part No. No. Description Size Qty 41...TS-1551061 ... Lock Washer ...M8 ..

18Wiring Diagram

2This manual has been prepared for the owner and operators of a PDS-12CS Sander. Its purpose, aside from machine operation, is to promote safety thr

3 WARNING Wear eye protection. Always keep guards in place and in proper operating condition. Do not operate the machine without the guards for an

4• ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE SERVICING. • REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure the switch is i

5Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfunctio

6230 Volt Operation If 230V, single phase operation is desired, the following instructions must be followed: 1. Disconnect the machine from the po

7Specifications PDS-12CS Stock Number...

8Contents of the Shipping Carton PDS-12CS 12” Disc Sander 1. Sander 1. Sanding Disc 1. Table 1. Miter Gauge 1. Miter Gauge Fence 1. Owner's Ma

9Stand Assembly 1. With the help of another person lift the sander (A, Fig. 1) onto the stand (B, Fig. 1). Feed the belt (C, Fig. 1) through the c