Jet-tools GH-1440ZX Bedienungsanleitung

Operating Instructions ZX Series Lathes Models GH-1440ZX/1460ZX GH-1640ZX/1660ZX GH-1840ZX/1860ZX/1880ZX GH-2280ZX WMH TOOL GROUP 2420 Va

10Unpacking Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not disca

11Uncrating and Cleanup 1. Finish removing the wooden crate from around the lathe. 2. Unbolt the lathe from the shipping crate bottom. 3. Choose a

12 3. Inspect the camlock studs. Make sure they have not become cracked or broken during transit. Clean all parts thoroughly with solvent. Also clea

13Drain oil completely and refill after the first three months of operation. Then, change oil in the apron annually. Pull knob (C, Figure 5) on the o

14 The main motor is rated at 7-1/2 HP (or 10HP for model 2280ZX), 230/460V and comes from the factory prewired at 230V. Confirm that power available

15Carriage The carriage (C, Figure 10) is made from high quality cast iron. The cross-slide (E, Figure 10) is mounted on the carriage and moves on a

16To set the steady rest: 1. Loosen three hex socket cap screws. 2. Loosen knurled screw and open sliding fingers until the steady rest can be move

175. Compound Slide (L, Figure 13) is located on top of the cross slide and can be rotated 360°. There are calibrations in degrees (M, Figure 13) be

18 15. Compound Rest Traverse Handle (J, Figure 13): Located on the end of the compound slide. Rotate clockwise or counterclockwise to position. 16.

19Operation Feed and Thread Selection 1. Reference the feed and thread chart on the front of the headstock (A, Figure 16). 2. Move levers and knobs

2 This manual has been prepared for the owner and operators of a JET ZX Series Lathe. Its purpose, aside from machine operation, is to promote safety

20Removing Gap Section 1. To remove the gap section, remove four hex socket cap screws, and two hex cap bolts. 2. Tighten the hex nuts on the tapere

3 Table of Contents Warranty and Service ...

4 Warning 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on t

5 21. Give your work undivided attention. Looking around, carrying on a conversation and “horse-play” are careless acts that can result in serious

6 The following specifications were current at the time this manual was published, but because of our policy of continuous improvement, WMH Tool Grou

7 Specifications Model Number... GH-1640ZX ... GH-166

8 Specifications Model Number.....GH-1840ZX...GH-1860ZX... GH-1880ZX Stock Nu

9 Specifications Model Number..............................